Помогите настроить VPN в Plesk, VPN на VPS Опции

[Kali]

Есть VPS с plesk.

Помогите настроить OpenVPN который идет встроенным модулем в Virtuozzo.

Немогу понять какие адреса брать для :

Local peer address * . . .
Remote peer address * . . .


(Two hosts connected by a VPN channel need to have a pair of virtual network interfaces to route the traffic through. You need to assign two IP addresses to them, one for each side of the VPN circuit. These IP addresses should be chosen from some private address spaces and it is important that they should not overlap with any of the IP addresses present in the local networks on either side of the tunnel. The two addresses you pick must differ only in the two least significant bits, these being 01 in one address and 10 in the other. You can pick .1 and .2 for the last octets, for example. Note that the default values are only an illustration! Always check the real configuration of your network so that you do not run into IP collision problems. )

Откуда вообще беруться эти адреса?

Чтобы я там не вводил
модуль отвечает -
Error: There was a problem starting or stopping the OpenVPN daemon:
psa-vpn: OpenVPN failed to start

Нужно ли спец. клиентское ПО или все можно настроить через все стандартныое в Win?

Пожалуйста помогите, можно в приват

С меня - причетается

icq 191-493-418